Угловой шаблон
Физический шаблон заданного угла с длиной плеч, толщиной и прорезями для разметки.
Configure the model
Review the parameters, then open the model in the builder. Change dimensions methodically and inspect the result before manufacturing.
Open in builderOutput and formats
The builder displays a 3D preview. Available export formats, design saving and ordering depend on the model and account permissions and are shown in the interface.
Parameters
| Parameter | Units | Range |
|---|---|---|
| Dimension by X - width | Shown in the builder | — – — |
| Dimension by Y - depth | Shown in the builder | — – — |
| Dimension by Z - height | Shown in the builder | — – — |
| Угол | Shown in the builder | 5.0 – 175.0 |
| Leg1 length | Shown in the builder | 40.0 – 300.0 |
| Leg2 length | Shown in the builder | 40.0 – 300.0 |
| Leg width | Shown in the builder | 12.0 – 70.0 |
| Thickness | Shown in the builder | 3.0 – 18.0 |
| Mark slots | Shown in the builder | — – — |
| Прорезь width | Shown in the builder | 0.5 – 5.0 |
| Прорезь start | Shown in the builder | 5.0 – 100.0 |
| Прорезь length | Shown in the builder | 10.0 – 180.0 |
| Pivot hole | Shown in the builder | — – — |
| Pivot hole diameter | Shown in the builder | 2.0 – 15.0 |
| Reference holes | Shown in the builder | 0.0 – 8.0 |
| Reference hole diameter | Shown in the builder | 1.0 – 6.0 |
| Edge lips | Shown in the builder | — – — |
| Lip height | Shown in the builder | 3.0 – 30.0 |
| Lip thickness | Shown in the builder | 1.5 – 8.0 |