Экономайзер для шпули
Настройте размеры шпули, леску, фаски и внутреннюю надпись.
Configure the model
Review the parameters, then open the model in the builder. Change dimensions methodically and inspect the result before manufacturing.
Open in builderOutput and formats
The builder displays a 3D preview. Available export formats, design saving and ordering depend on the model and account permissions and are shown in the interface.
Parameters
| Parameter | Units | Range |
|---|---|---|
| Dimension by X - width | Shown in the builder | — – — |
| Dimension by Y - depth | Shown in the builder | — – — |
| Dimension by Z - height | Shown in the builder | — – — |
| A — lower diameter | Shown in the builder | 10.0 – 150.0 |
| A — upper diameter | Shown in the builder | 10.0 – 150.0 |
| B — рабочая height | Shown in the builder | 5.0 – 80.0 |
| D — diameter намотки | Shown in the builder | 15.0 – 250.0 |
| Diameter лески / шнура | Shown in the builder | 0.05 – 5.0 |
| Length лески / шнура | Shown in the builder | 0.0 – 1000.0 |
| Если леска не помещается | Shown in the builder | — – — |
| Нижняя facet — width | Shown in the builder | 0.0 – 4.0 |
| Нижняя facet — множитель высоты | Shown in the builder | 0.0 – 10.0 |
| Нижняя facet — тип | Shown in the builder | — – — |
| Top chassis — width | Shown in the builder | 0.0 – 4.0 |
| Top chassis — множитель высоты | Shown in the builder | 0.0 – 10.0 |
| Top chassis — тип | Shown in the builder | — – — |
| Lettering | Shown in the builder | — – — |
| Height letter | Shown in the builder | 1.2 – 5.0 |
| Regime detail | Shown in the builder | — – — |
| Show me шпулю | Shown in the builder | — – — |
| Шпуля в разрезе | Shown in the builder | — – — |
| Прозрачная шпуля | Shown in the builder | — – — |
| Show me фаски | Shown in the builder | — – — |
| Volume намотки | Shown in the builder | — – — |
| Show me леску | Shown in the builder | — – — |