Воронка
Воронка по входному и выходному диаметрам, высоте, длине носика, толщине стенки, буртику и ручке.
Configure the model
Review the parameters, then open the model in the builder. Change dimensions methodically and inspect the result before manufacturing.
Open in builderOutput and formats
The builder displays a 3D preview. Available export formats, design saving and ordering depend on the model and account permissions and are shown in the interface.
Parameters
| Parameter | Units | Range |
|---|---|---|
| Dimension by X - width | Shown in the builder | — – — |
| Dimension by Y - depth | Shown in the builder | — – — |
| Dimension by Z - height | Shown in the builder | — – — |
| Верхний diameter | Shown in the builder | 25.0 – 300.0 |
| Outlet diameter | Shown in the builder | 5.0 – 100.0 |
| Funnel height | Shown in the builder | 20.0 – 220.0 |
| Spout length | Shown in the builder | 10.0 – 180.0 |
| Wall | Shown in the builder | 1.0 – 8.0 |
| Displacement носика от центра | Shown in the builder | -60.0 – 60.0 |
| Outlet displacement y | Shown in the builder | -60.0 – 60.0 |
| Rim style | Shown in the builder | — – — |
| Rim width | Shown in the builder | 0.0 – 18.0 |
| Rim height | Shown in the builder | 1.0 – 8.0 |
| Spout taper | Shown in the builder | -8.0 – 8.0 |
| Barb count | Shown in the builder | 0.0 – 5.0 |
| Barb height | Shown in the builder | 0.2 – 2.5 |
| Handle | Shown in the builder | — – — |
| Handle internal | Shown in the builder | 10.0 – 40.0 |
| Landing tabs | Shown in the builder | 0.0 – 4.0 |
| Tab hole | Shown in the builder | 2.0 – 12.0 |