Коробка для лазерной резки
Коробка по ширине, глубине, высоте и толщине материала; собранный 3D-вид или плоский раскрой, ручка и kerf.
Configure the model
Review the parameters, then open the model in the builder. Change dimensions methodically and inspect the result before manufacturing.
Open in builderOutput and formats
The builder displays a 3D preview. Available export formats, design saving and ordering depend on the model and account permissions and are shown in the interface.
Parameters
| Parameter | Units | Range |
|---|---|---|
| Dimension by X - width | Shown in the builder | — – — |
| Dimension by Y - depth | Shown in the builder | — – — |
| Dimension by Z - height | Shown in the builder | — – — |
| Width | Shown in the builder | 40.0 – 500.0 |
| Depth | Shown in the builder | 40.0 – 500.0 |
| Height | Shown in the builder | 30.0 – 400.0 |
| Material | Shown in the builder | 1.0 – 20.0 |
| Внутренний dimensions | Shown in the builder | — – — |
| Open upper | Shown in the builder | — – — |
| Open lower | Shown in the builder | — – — |
| Нижний inset | Shown in the builder | 0.0 – 20.0 |
| Finger width | Shown in the builder | 4.0 – 40.0 |
| Finger margin | Shown in the builder | 0.0 – 20.0 |
| Kerf | Shown in the builder | 0.0 – 1.5 |
| Hinge ears | Shown in the builder | — – — |
| Ear diameter | Shown in the builder | 3.0 – 20.0 |
| Handles | Shown in the builder | — – — |
| Handle width | Shown in the builder | 0.0 – 180.0 |
| Handle height | Shown in the builder | 0.0 – 70.0 |
| Handle margin upper | Shown in the builder | 3.0 – 60.0 |
| Rivet holes | Shown in the builder | — – — |
| Rivet hole diameter | Shown in the builder | 1.0 – 8.0 |
| Rivet spacing | Shown in the builder | 15.0 – 150.0 |
| Dividers x | Shown in the builder | 0.0 – 8.0 |
| Dividers y | Shown in the builder | 0.0 – 8.0 |
| Divider height ratio | Shown in the builder | 0.3 – 1.0 |
| Mode | Shown in the builder | — – — |
| Cut plan gap | Shown in the builder | 3.0 – 40.0 |