стелька
A parametric model configurable in the ABGUL builder.
Configure the model
Review the parameters, then open the model in the builder. Change dimensions methodically and inspect the result before manufacturing.
Open in builderOutput and formats
The builder displays a 3D preview. Available export formats, design saving and ordering depend on the model and account permissions and are shown in the interface.
Parameters
| Parameter | Units | Range |
|---|---|---|
| Dimension by X - width | Shown in the builder | — – — |
| Dimension by Y - depth | Shown in the builder | — – — |
| Dimension by Z - height | Shown in the builder | — – — |
| Thickness пяточной zone | Shown in the builder | 1.0 – 20.0 |
| Height продольного свода | Shown in the builder | 1.0 – 40.0 |
| Отклонение пяточной zone | Shown in the builder | 1.0 – 40.0 |
| Отклонение пальцевой zone | Shown in the builder | 1.0 – 25.0 |
| Height валика Зейтца | Shown in the builder | 0.0 – 30.0 |
| Displacement поперёк стельки. 0 = геометрический центр. | Shown in the builder | -45.0 – 45.0 |
| Displacement вдоль стельки. 0 = геометрический центр. | Shown in the builder | -90.0 – 90.0 |
| Diameter/width валика. Mold масштабируется пропорционально по X и Y. | Shown in the builder | 15.0 – 80.0 |
| Thickness стельки | Shown in the builder | 1.0 – 8.0 |
| Stop from the report | Shown in the builder | — – — |
| Length of foot | Shown in the builder | 120 – 400 |
| Front section width | Shown in the builder | 30 – 180 |
| The width of the middle department | Shown in the builder | 20 – 180 |
| Width of heel zone | Shown in the builder | 20 – 150 |
| Medial vault height | Shown in the builder | 0 – 60 |