Контейнер / лоток
Открытый контейнер с размерами, стенкой, дном, пониженным передним бортом и площадкой под этикетку.
Configure the model
Review the parameters, then open the model in the builder. Change dimensions methodically and inspect the result before manufacturing.
Open in builderOutput and formats
The builder displays a 3D preview. Available export formats, design saving and ordering depend on the model and account permissions and are shown in the interface.
Parameters
| Parameter | Units | Range |
|---|---|---|
| Dimension by X - width | Shown in the builder | — – — |
| Dimension by Y - depth | Shown in the builder | — – — |
| Dimension by Z - height | Shown in the builder | — – — |
| Width | Shown in the builder | 40.0 – 350.0 |
| Depth | Shown in the builder | 40.0 – 300.0 |
| Height | Shown in the builder | 30.0 – 260.0 |
| Wall | Shown in the builder | 1.2 – 8.0 |
| Нижний | Shown in the builder | 1.5 – 10.0 |
| Corner radius | Shown in the builder | 0.0 – 20.0 |
| Передний drop | Shown in the builder | 0.0 – 80.0 |
| Dividers x | Shown in the builder | 0.0 – 8.0 |
| Dividers y | Shown in the builder | 0.0 – 8.0 |
| Divider height ratio | Shown in the builder | 0.2 – 1.0 |
| Label lip | Shown in the builder | — – — |
| Label height | Shown in the builder | 8.0 – 45.0 |
| Label angle | Shown in the builder | 0.0 – 45.0 |
| Handle cutout | Shown in the builder | — – — |
| Handle width | Shown in the builder | 20.0 – 150.0 |
| Handle height | Shown in the builder | 8.0 – 50.0 |
| Stack lip | Shown in the builder | — – — |
| Stack lip height | Shown in the builder | 1.0 – 10.0 |
| Drain holes | Shown in the builder | 0.0 – 16.0 |
| Drain hole diameter | Shown in the builder | 1.0 – 12.0 |