Болт / фиксатор панели
Печатный фиксатор с диаметром и длиной стержня, головкой и шестигранным гнездом.
Configure the model
Review the parameters, then open the model in the builder. Change dimensions methodically and inspect the result before manufacturing.
Open in builderOutput and formats
The builder displays a 3D preview. Available export formats, design saving and ordering depend on the model and account permissions and are shown in the interface.
Parameters
| Parameter | Units | Range |
|---|---|---|
| Dimension by X - width | Shown in the builder | — – — |
| Dimension by Y - depth | Shown in the builder | — – — |
| Dimension by Z - height | Shown in the builder | — – — |
| Shaft diameter | Shown in the builder | 4.0 – 20.0 |
| Shaft length | Shown in the builder | 10.0 – 90.0 |
| Shaft taper | Shown in the builder | -2.0 – 2.0 |
| Clearance | Shown in the builder | 0.0 – 1.5 |
| Retention rings | Shown in the builder | 0.0 – 5.0 |
| Ring height | Shown in the builder | 0.2 – 2.0 |
| Head style | Shown in the builder | — – — |
| Head diameter | Shown in the builder | 12.0 – 55.0 |
| Head height | Shown in the builder | 4.0 – 22.0 |
| Washer flange | Shown in the builder | 0.0 – 10.0 |
| Socket type | Shown in the builder | — – — |
| Socket width | Shown in the builder | 2.0 – 12.0 |
| Socket depth | Shown in the builder | 1.0 – 12.0 |
| Cross hole | Shown in the builder | 0.0 – 8.0 |